S-GA44Q FUEL DISPENSER

S-GA44Q FUEL DISPENSER

FlowMeter Type : Optional

Accuracy : ±0.2%

Pressure Loss (kg/cm): Under 0.25

Motor Voltage(V): 110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle :Auto Shut-off Nozzle

Environmental Condition : : -40~~+55degree

Control :Type Solenold Vale Control Type

Preset :Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume :0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount :0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Optional Display: Type LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price: 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer :1~~9,999,999

Hose: 4.5m

Weight : 330kg.

Dimension(L×W×H) :1270*560*2200(mm)

Dimension(L×W×H)Of Qty of Container : 40ft: 26

. Examine clearance and replace relevant components when necessary. 1.4. Measurement transducer block 1.5. No discharge due to Solenoid valve closed. First check electric wiring, then trouble on component itself (short circuit of winding or block in valve membrane, etc). 1.6. Pipeline and bottom valve failure If continuously exhaust in vapor separator from beginning, disconnect filter cover and take out filter net; pour same kind of oil in it and given see oil level quickly drop, there is leakage occurred in pipeline and bottom valve. 1.7. No discharge caused by nozzle failure Jam in jointer or filter. Unlock strainer or jointer to remove dirt and waste. Nozzle always in auto-shut state, check automatic shut device, mainly inlet vent, spring. 1.8. Bottom valve be stuck in and pipeline is plugged. Exterior reasons for no delivery Oil level is so lower than bottom valve that pump can’t suck oil. Some valve(s) is closed in pipeline between tank and fuel dispensers. Air goes into valve(s). Single phase valve is rusted in bottom valve. Incorrect installation of flange causes leakage between inlet pipe and fuel dispenser. Inappropriate oil is refueled. Oil is easy to gasify; water in oil freeze; wax in fuel dispenser oil plug pipe. Pipe design is unsuitable. Two fuel dispensers, for example, are connected in same pipeline without valve, or valve can’t shut completely; pipeline has many crooks or too thin. Slow flow rate as starting 3.1. Strainers, including cone-shaped filter net and nozzle filter net, are jammed. 3.2. Large amount of air flow into from broken parts or pipeline, causing muc fuel dispenser h foam in oil indicator. 3.3. Large noise and vibration during operation Vacuum pressure is inadequate. Leakage occurs in overflow valve or pump gasket. Inner leakage in fuel dispenser increase as serious abrasion in pump vane or vane is stuck by waste. Vapor separator trouble Small floater of vapor separator is broken or fall down; insufficient pressure in high pressure chamber as exhausting valve can fuel dispenser

Base　　 - Calculator Data Base　　 - Extra text explaining the operation for Data_Id s　　 2 3 4 5 6 7 21 22 23 24 26 40 41 42 43 44 45 when that do not permit　　 the Data_Id to be changed remotely.　　 - Added optional Data_Id 46 Price_Set_Nb.　　 - 3.4 Meter Data Base　　 - Extra text explaining operation when Data_Id 1(Meter_Type) Data_Id 2　　 (Meter_Puls_Vol_Fact) Data_Id 4(PR_Id) are not configured.　　 - 3.6 Product Data Per Fuelling Mode　　 - Data_Id s 2(Prod_Price) 3(Max_Vol) 4(Max_Fill_Time) 5　　 (Max_Auth_Time) can now be written to in state 5 (Authorised).　　 - Data_Id 4(Max_Fill_Time) has extra text regarding defaults after a master　　 resetcold start and handling when Data_Id can not be written to.　　 - 3.7 Fuelling Point Data Base　　 - Data_Id s 2(Nb_Tran_Buffer_Not_Paid) 3( fuel dispenser Nb_of_Historic_Trans)　　 4(Nb_Logical_Nozzle) have additional text explaining what to do when　　 a write action occurs with a value that can not be supported.　　 - Optional Data_Id 42(Current_Price_Set_Nb) added.　　 - Extra text explaining what action to take w fuel dispenser hen a state error occurs with　　 one of the commands (Open Close Release Resume Suspend　　 terminate).　　 - 3.8 Logical Nozzle Data Base　　 - Data_Id s 1(PR_Id) 7(Meter_1_Id) have additional text explaining　　 fuel dispenser

nion-led protests against its labour reforms, such a statement might seem surprising. It was made recently by Nicolas Sarkozy, the interior minister and head of the ruling centre-right UMP party—and he has a point. Despite their show of strength, France s trade unions are a declining force. This is not how it feels. This week, Bernard Thibault coasted to an unopposed re-election as head of the Confédération Générale du Travail (CGT), the country s biggest union, at its congress in Lille. He basked in the glory of the protests, which drew up to 3m people on to the streets and forced Dominique de Villepin, the prime minister, to abandon his new flexible job contract for the young. Mr Thibault had been under pressure within the communist-backed union. It had failed in previous confrontations with the government, and Mr Thibault had lost the battle to stop it coming out against the European Union constitution. Now, flush with victory on the streets, he will enjoy renewed authority, and a third term, at the age of only 47. To loud applause, Mr Thibault congratulated his members on a “beautiful page written by French trade unionism� He stressed the importance of unity the five main unions had stood shoulde fuel dispenser r-to- shoulder against Mr de Villepin, avoiding splits that have weakened them in the past. And he called for a new campaign, this time against another job contract, the contrat nouvelle embauche, introduced last year by Mr de Villepin. A day of action is promised on May 1st. Behind this muscular display, however, is a more nuanced reality. After 50 years of decline, just over fuel dispenser 8% of workers in France belong to a trade union, compared with 12% in America, and nearly 30% in Britain (see chart). With some 700,000 members, the CGT is less than a third as big as IG Metall in Germany. It has lost two-thirds of its membership since the 1970s. Union clout is now concentrated in the public sector one in four energy workers is a union member, but in the private sector union penetrati fuel dispenser